Step 1: Set the tyres to the following pressures,

Tyre position Tyre pressure (psi)
Front LH (34)
Front RH (31)
Rear RH (29)
Rear LH (26)

Step 2: Locate the TPMS interface plug*(See note). This is a white female plug that is attached to the OBD II wire loom under the dash right about where your left knee would be when sitting in the driver’s seat. You may have to cut the tape that is holding the TPMS interface plug to the OBD II wire loom.

Step 3: Attach a paper clip or wire into the interface plug.

Step 4: Put your key in the ignition and turn it to the last click before the engine starts. This is the KOEO position (Key On, Engine Off).

Step 5: Tap the end of the paper clip (the end NOT in the interface plug, duh!) on any exposed ground (metal) 5 times.

Step 6: If you completed step 5 then the TPMS warning light will start to slowly flash and you have activated the TPMS relearn process. If it flashes fast or solid that’s not right. If yours isn’t flashing slowly then check your connections, turn the ignition off and start over at step 4.

Note: if you’re having trouble getting it into the relearn mode, try grounding the connector, turn the car on, then turn the car off while still grounding it. Then repeat the above steps.

Step 7: Once you confirm the lights do not stop flashing, step on the clutch/brake and start the car. Do not turn the car to OFF position. Start driving >25mph until the light goes out. It could take as long as ten minutes.

Step 8: The light will quickly come back on due to the low tyre pressures. Refill your tyres to the correct pressure.


*Note – The plug is attached to the wire loom , you may need to cut away some insulation tape to reveal it but not all cars have this plug fitted and those without will need a reset tool